Publications Office of the EU
Multivariable command and control of thickness profile, camber and flatness by topometrical measurements and hybrid models for heavy plate mills
DisplayCustomHeader
MyPortal
suomi
BasketSummary
Web-sisällön esitys
Publication Detail Actions Portlet

Näytönluku

Publication Detail Actions Portlet
 Käyttäjän arvosana
custom-survey-notification
Publication Detail Portlet

Publication detail

Home

Multivariable command and control of thickness profile, camber and flatness by topometrical measurements and hybrid models for heavy plate mills

Final report

Julkaisun metatiedot

ln order to achieve an enhanced shape and thickness profile and reduce camber and ski during plate rolling, detailed area information about varying geometric features along and across the plate had to be measured and exploited by advanced command and control strategies, which had to be derived from adequate models of varied techniques. For that purpose, a new shape inspection system, as well as a new thermo sensor and topometrical area measurement system TopPlan, to measure the total surface topography of the plate online, have been developed, respectively adapted and set into operation. An offline model of the finishing stand of the Corus Plate Mill at Scunthorpe has been developed and calibrated to predict rolled plate profile and flatness, and camber. This was done in terms of a more simple approach and in a comprehensive FE model, in which the mill housing, chocks and screws are also meshed in addition to the rolls and stock. Extensive analysis has confirmed that simple approaches to ski reduction by balance of top and bottom roll speed and torque does not work every time. Thus, a comprehensive pass to pass control concept was drafted, based on online ski measurement and on models adapted from pass to pass, that optimises the command variables for speed and torque balance control. A new multivariable controller prototype for a thickness cross-sectional profile was built up, that acts simultaneously by the screw downs at the drive and the operator side. Due to simulation results, based on real measurement data, it is working well. Thus, an essential component is available to be used as a cross-sectional thickness control or as an essential component in an integrated multivariable profile and camber control, with an online TopPlan camber measurement available.
Näytä lisää
Näytä vähemmän
ISBN 92-894-7435-1
Luettelonumero KI-NA-20-932-EN-S
Paperikopio
ISSN ISBN 92-894-7435-1 DOI Luettelonumero KI-NA-20-932-EN-S
  • Released on EU publications website:
Tämä julkaisu on ladattavissa sekä verkkokäyttöön tarkoitettuna PDF-tiedostona että tulostusvalmiina PDF/X-tiedostona. Lisätietoja EU:n julkaisujen oman kopion tulostamisesta on Usein kysyttyä -osiossa.
Publication Viewer

Tiedoston katseluohjelma

Pop up window annotations